4, 6 & 8 Channel Multi-Port Switch 5.00 3

CONTROL UP TO 8 CIRCUITS FROM 1 CHANNEL

EXTEND THE OPERATING SCOPE OF YOUR RC SYSTEM

QUALITY MADE BRITISH PRODUCT FEATURES

FEATURES AND SPECIFICATIONS

• Available in Two Switch Pattern Options with 4,6 & 8 Ports
• Microprocessor ‘Glitch Free’ Control
• SMT Design (Not socketed IC's)
• Switches Loads up to 1.2A (1,200mA) at 55v
• Controlled by Switch, Rotary Knob or Stick on your Transmitter
• Built in Activity Status LED
• Current Draw 12mA engaged. 2.1mA in quiescent state.
• Small 30mm x 30mm footprint.
• Ultra Lightweight. Only 10g!

Applications

• Multiple Lighting Systems LED’s, ‘Grains of Wheat’ etc.
• Small Motor Control (Radar Scanner, small pumps etc.)
• Animated Crew Actions
• Relay Driver for Heavier Loads
• Small Solenoid Driver

Download the Product Information Sheet

Introducing our latest design in RC Switching and Control, this remarkable innovative Module which will allow you to switch On and Off Four (4) separate circuits from a single Radio Control Channel. The module is an Electronic 4 Port Sequential Switch which is cycled through each Port, 1 - 4 by an On/Off Signal on a Switched, Stick or Rotary Knob Channel.

This is a hand crafted Surface Mount Technology (SMT), professionally designed all British module, built with top quality RoHS (Restriction of Hazardous Substances Directive) high specification components.

The circuit independently switches Direct Current (DC) power from a separate supply over a pair of Supply connectors ready for you to plug in and connect up to your Project.

The switching process explained.

SEQUENTIAL PATTERN
Traversing the Channel Stick or Rotary Knob from Off to On then Off invokes the Module to Turn on and Hold Port 1. Switching the same Channel Switch from Off to On then Off again, invokes the module to Turn Off Port 1, and Turn On Port 2, and so on for Ports 3 and 4. After Port 4 is turned off, the next step turns all 4 ports On, with the final step being to turn Off all Ports Ports.

Each Time a Switching action is received the Activity LED Illuminates. Switching Forward is displayed by a The LED Illuminating and staying lit until the Stick is Back at Centre/Dead Position.

INDEPENDENT SWITCH PATTERN (NEW FEATURE)
A stick forward motion from Centre Stick/Dead Stick switches a Port On and Off. If it was already On then this action will switch it off. If it was already Off then this action will switch it on.

A stick reverse motion from Centre Stick/Dead Stick advances the Port by one Port at a time in a sequence from Ports 1 to 4 (/6/8)

Each Time a Switching action is received (Forward of Reverse) the Activity LED Illuminates. Switching Stick Forward/Reverse is displayed by a The LED Illuminating and staying lit until the Stick is Back at Centre/Dead Position.

An Status LED clearly visible through protective shroud gives you a function indication on start-up.

Once again MOSFET Power Control Technology is used as the Switching Component controlling each Port. Only Top Quality MOSFET's (Metal Oxide Semiconductor Field-Effect Transistors) only are used in the production of these modules guaranteeing you many years of useful service (providing you do not abuse it!)

Each Port will handle up to 1,200mA (1.2A) which in essence is 48 LED’s or 25 ‘Grains of Wheat’ incandescent lamps.

Each MOSFET is protected by a Back EMF Shottky Diode allowing you to drive a small motor.

The module plugs directly into a controlled channel on your RC Receiver and when installed draws approximately 8mA in active state and 2.8mA in quiescent state.